Dynatek Dyna 2000i Programmable Ignition Module | Blue

Dynatek Dyna 2000i Programmable Ignition Module is simply adjusted using switches; nothing else is required. Another new feature is data recording. The module records and maintains a sequence of data points. The recorded data can be downloaded to a PC to demonstrate engine builders how the engine was used (or misused), in case there is an issue in the future.

Features:

• Adjustable using switches
• Fully programmable with the extra programming kit (902528) and harness (902524)
• Intelligent overvoltage / over-current protection
• Short circuit protection
• Configurable retard timing
• Data recording

Perqusits: 

• Coil must be within range of 2.5 to 3.5 ohms. 
• Carbon, graphite or spiral core type suppression spark plug wires are required. Do not use copper core wires.

What could be programmed using PC for it?

• Eight point definable wide open throttle curve. 
• Eight point fully definable partial throttle curve. 
• Rev. limiter in 50 RPM steps. 
• Programmable dead cranking revs 0-10. 
• Programmable rear cylinder offset of +/- 10 degrees. 

What recording it does?

• Total engine hours run time. 
• Time at wide open throttle. 
• Longest time operating at wide open throttle. 
• The number of engine starts (Two minutes' running counts as one). 
• Maximum RPM. 
• Seconds near the rev limit. 
• Statistical analysis of time at RPM. 

Compatibility: 

• 70-99 Big Twin models (excluding Twin Cam) 
• 71-03 XL Sportster (NU)

Note: It is not compatible with kick start models.

Note1: It is recommended to use ignition modules & coils from the same manufacturer. Intermixing different brands may cause premature failure.

Note2: Dyna does not offer the ignition rotor. The OEM Harley rotor (OEM 32402-83) and mounting bolt (OEM 2611B) should be re-used or ordered separately as 920402 rotor & bolt kit. 
Note3: Optional programming kit is available as 902528 (Incl. software, USB connections and operating instructions). The programming harness 902524 (Programming harness, Pigtail. Installs on bike, it is the link between ignition and the USB) is required to program the 2000i ignition module.